11
FR
Informations pratiques
C
11
EN
Using the appliance
B
Gas change
WARNING
The following procedures must be carried out by a qualified
technician.
Your cooker has been designed to operate with either liquefied petroleum gas (butane or
propane) or natural gas. The burners can be adapted to these different gas types by replacing
the corresponding injectors and adjusting the minimum flame length of each burner. The
following steps must be taken: Procedure for changing injectors:
Hob burners:
• Shut off the main gas supply and unplug the electrical socket.
•
Remove the burner cap and the upper burner (figure 9).
•
Unscrew the injectors. Use a 7 mm allen key to do this (figure 10).
• Position the new injectors, in line with the correct gas type used, using the technical
information table as a reference. Make sure that the new injectors are screwed on straight.
If you assemble them at an angle, you risk damaging the support moulding and the support
will then need to be replaced (not covered by the guarantee).
Clé à molette
Injecteur
Pipe spanner
Injector
