User's Guide _______________________________________________________________________
78 ___________________________________________________________________ M210243en-A
NOTE
The base plate may be mounted to hard surfaces like concrete by
replacing the pegs with screws and rawl plugs. For temporary
mounting on hard surfaces use heavy weights on the four corners of
the base plate. The height of the weights should be kept as low as
possible to cause the minimum interference with the aerodynamics of
the rain gauge.
Installing on a Pedestal
1.
Drill out three holes in the base to the 6.5 mm in diameter and
clean off burr. For details, see Figure 71 below.
2.
For the pegs, drill out a hole in the each corner of the pedestal
plate. Clean off burr.
0002-011
Figure 71
Rain Gauge Pedestal Plate Dimensions
3.
Place the pedestal plate with rain gauge assembly on the ground
using the pegs supplied. If force is needed, then remove the rain
gauge first. See Figure 72 on page 79.