User's Guide _______________________________________________________________________
130 __________________________________________________________________ M210243en-A
removes the source file.
open
Opens the terminal connection.
pslevel
pslevel [meters]. To see the current pressure sensor level, type
pslevel
. To
change the pressure sensor level, type
pslevel
and the new pressure
sensor level in meters from the station altitude.
rd
rd <path> removes directory
rep
rep <report_name> shows contents of a report report_name. E.g. "rep
MyRep0".
reset
reset [delay (seconds)] resets MAWS (warm boot). If the delay time is not
typed, MAWS resets immediately.
serial
serial <port_number> [speed] [parity] [bits] [stop]. To see the settings of the
port number 0, type
serial 0
. To change the settings, type
serial 0
and the
new parameters. E.g. "serial 0 9600 N 8 1". Available ranges/options:
Speed 300-19200, Parity N/O/E, Bits 7/8, Stop 0/1.
SLEEP
Sets MAWS in low power-state. Use the
SLEEP
command to reduce
power consumption when storing the station for a few days (maximum
period 1 month). Tip the spoon of the rain gauge to wake up MAWS.
MAWS can also be woken up by pressing the reset button.
NOTE! The
SLEEP
command must be written in upper case.
sname
sname [station_name]. To see the current station name, type
sname
. To
change the name, type
sname
and the new name. If the station name
begins with a digit or contains a space, the name must be in quotes e.g.
sname "Vaisala MAWS".
spclear
spclear <parameter/ALL> clears a static parameter/all parameters.
NOTE! This command clears QMS101 and QMN101 sensitivity settings
and is not usually needed.
spset
spset [parameter] [value] sets a value to a static parameter. To see a list of
static parameters, type
spset
.
NOTE! This command is not usually needed.
SYSINFO
SYSINFO gives information on the system.
NOTE! The command must be written in upper case.
time
time [HH MM SS YY MM DD]. To see the current time, type
time
. To
change the current time, type
time
and the new time. E.g. "time 14 10 00".
To change the current date, type
time
and the new time and date e.g. "time
14 10 00 98 12 31".
timezone
timezone [hours] sets the time difference from UTC. To see the time zone,
type
timezone
. To set the time zone, type e.g. "timezone 2".
userlevel
userlevel
[level <set/clear>]command is used to protect system from
unauthorized use. It provides three password protected access levels to
shell commands as well as to the visibility of system data. By default, the
user levels are not in use.
verify
verify <source file> <destination file> verifies file(s)
warnings
warnings [clear]. To see active warnings, type
warnings
. To clear active
warnings, type
warnings clear
. Warnings indicate that there are some
problems in the software. See the Troubleshooting chapter on page 153 for
more information.
winddircal0
winddircal0 [direction]. Set the direction in degrees to align the wind vane.
Type for example "winddircal0 360" (north).
zr
Zmodem receive command is needed when transferring the setup file to
MAWS.
zs
zs <file_name>. Sends a file from MAWS using Zmodem protocol.
