ELECTRICAL CONNECTION
vacon • 36
24-hour s358 (0)201 212 575 • Email: [email protected]
5
5.6
Option board OPTD2
Note!
This figure presents the layout of D2 board version H or later. See Chapter
Jumper selections below.
I/O terminals on OPTD2
Description:
System Bus adapter board with single optical input and output; Interface to
fast mon-
itor bus used by the NCDrive PC tool.
Allowed slots:
(B,)D, E;
Note: If only the Monitor Bus (terminals 21 to 23) is used the board
can also be placed in slot B. The System Bus is then unavailable. Remove
therefore jumpers X5 and X6. See page 36.
Type ID:
17458
Terminals:
Single optical input and output; one screw terminal block (M3),
Agilent HFBR-1528 (Receiver), HFBR-2528 (Transmitter).
Jumpers:
4; X3, X4, X5 and X6. See page 36
Board
parameters:
None
Terminal
Technical information
1
H1
System Bus optical input 1 (RX1)
Use 1-mm optical cable (e.g. Agilent HFBR-RUS500 &
HFBR-4531/4532/ 4533 connectors)
Note: Not available if the board is placed in slot B
2
H2
System Bus optical output 1/2 (TX1/TX2);
Selected with jumper X5
Use 1-mm optical cable (e.g. Agilent HFBR-RUS500 &
HFBR-4531/4532/4533 connectors)
Note: Not available if the board is placed in slot B
21
CAN_L
Monitor Bus negative data
22
CAN_H
Monitor Bus positive data
23
CAN_SHIELD
Monitor Bus shield
H1
H2
