4 Care and maintenance
Removing/Installing
▸ Pull the glass canopy completely out
and remove the grease filters.
▸ Tilt the front of the activated charcoal
filter unit
1
downwards and pull for-
wards out of the bracket.
▸ Remove the activated charcoal filter
unit
1
from the appliance housing
2
.
▸ Remove the activated charcoal filter
mat
3
from its frame
4
.
▸ Reassemble in the reverse order.
1
2
4
3
Cleaning and reactivating
▸ Clean the activated charcoal filter mat
3
in the dishwasher.
▸ Select an «intensive» or «heavy» dishwasher programme with a warm prewash. Wash
separately so that no food debris can become stuck to the activated charcoal filter
mat filter
3
.
If no dishwasher is available:
▸ Clean the activated charcoal filter mat
3
with hot water and detergent and then soak in
hot water in the sink for an hour. Rinse well afterwards.
▸ To reactivate the activated charcoal, the activated charcoal filter mat
3
without the
frame
4
must be dried in the oven.
▸ Select top/bottom heat or hot air and set the temperature to 100 °C. Place the activ-
ated charcoal filter mat
3
on the wire shelf and allow to dry for an hour.
The spent long-life activated charcoal filter can be disposed of in the household
waste or at a suitable recycling point.
Resetting the saturation indicator
▸ With the appliance switched on, hold the
button depressed for 2 seconds to reset
the saturation indicator.
▸ All the displays illuminate briefly if reset correctly.
If all the displays are still flashing after the reset, the reason for this is: the metal
grease or activated charcoal filters are also dirty and must be cleaned or replaced.
13