UWE P90, Operating And Assembly Instructions Manual

Page: 34 / 77

34
9.2 Acrylic panes
Do not operate the unit without the acrylic sheets
Replacing the acrylic sheets
The acrylic sheets are made of special plastic with high UV penetrability. Therefore, when
replacing, never use window glass or standard acrylic, as these filter the UV radiation either
partially or completely. Always order the original acrylic sheets from your specialized dealer or
unit manufacturer. Upon delivery of replacements, the acrylic sheets are covered on both sides
with a protective foil.
Remove the foil before installing in the tanning unit.
Do not operate the unit without acrylic sheets, as cooling of the unit cannot otherwise be
ensured.
In the event of damages, the manufacturer assumes no liability.
LIGHTGLASS
The acrylic panel of the bed top is frosted on the backside.
Replacing the bed panel
Make certain that the gas springs are dismounted first
and then the bed hinges! Otherwise, there is a danger
that the gas springs will be released in an
uncontrolled manner!
1. Unlock the two acrylic locks (6-1/2+3) with the Allen key.
2. Raise the acrylic sheet bed (6-1/1) upward. The acrylic sheet
bed is held in open position by the two gas springs. The air
separation sheet is held parallel to the acrylic sheet bed by the
two restraining cables.
3. Unfasten the two mounts on the air separation sheet.
4. Remove the air separation sheet from the bed.
5. Unfasten the gas springs at the upper anchors by removing the
locking element.
6. Use an open-end wrench to remove the lower ball-and-socket
joint (6-2/4) from the bed and remove the gas spring (6-2/3).
7. Remove the acrylic sheet bed from the bed.
8. Dismount the left (6-1/5) and right (6-1/4) hinges with a size
13mm box wrench and use a size 13mm open-end wrench to
counterturn.
9. Remove the acrylic sheet bed.