UV Pure Technologies Crossfire Technology Hallett 1000NC, Instruction Manual

Page: 31 / 52

Hallett Instruction Manual
Released on 8-Aug-19
– GH2B
Page 31 UV Pure Technologies Inc. © 2019
should be replaced every 12 or 16 months for optimum performance
– see
Product Specification Tables for lamp lifetimes. Note that lamps will only
decay while in operation. Shutting down the system for seasonal use will
extend lamp life.
The unit has an internal timer to keep track of the lifetime of the lamps. The
Hallett will issue a warning when the end of lamp lifetime approaches and it
will warn again when the lamp lifetime is exceeded. The amount of life
remaining on the lamps is measured in days and can be seen in the Home
menu.
The lamps can be replaced in a few minutes. See Figures 7.3-7.5.
Caution: Do not allow water to flow until new lamps have been
installed and reach full power.
Never touch the bulb (quartz portion) of a lamp with your fingers. Handle the
lamp by its ends only. If the surface of the lamp becomes dusty or dirty, use a
clean lint-free cloth and some rubbing alcohol to remove the dirt. For more
difficult stains such as water spots, use a scale remover to remove the stain
and then rubbing alcohol afterwards.
Tools Needed

Slotted screwdriver
NOTE: Resetting the Lamp Lifetime counter will clear the Message History,
Lamp Starts counter and Power Ups counter. If this information is required,
review it first before proceeding to Step 1.
Step 1:
Open the UV chamber as described in Accessing UV Chamber
section.
Step 2: Use a slotted screwdriver and pry the lamps up between lamp base
and ceramic socket.
When the bottom pins have disengaged the socket, lift the lamp up, then
swing the lamp base away from socket. Lower the lamp to disengage it from
the top lamp holder. With the lamp free from the unit, carefully place it aside
and remove the other lamp.
Dispose of the old lamps in the same way as you would dispose of ordinary
fluorescent tubes. Note that old lamps should be disposed of at a household
waste management depot or transfer station; contact your local recycling and
waste management authority for proper disposal procedures in your area.