© 2018 Utilicor Technologies Inc.
minicor-3 V1.5
11
MAINTENANCE SAFETY
Before adjusting or servicing the minicor-3, raise the coring drum to its
maximum height. If raising the minicor to service the coring drum block up
the arms into place.
Remove hydraulic pressure prior to doing any maintenance. Place the
minicor-3 on the ground or securely blocked up, and turn off the engine.
With the engine off and the key in the ACC position toggle hydraulic flow
controls on and off to release the pressure in the lines.
Repair or replace componetne in a safe area, away from road traffic and
other hazards.
Repair loose lines and loose hoses. Repair damaged lines and damaged
hoses. Leaks can cause fires. Do not bend high pressure lines. Do not strike
high pressure lines. Do not install bent lines or kinked hoses. Do not install
damaged lines or damaged hoses.
Before working on this machine, drive to a level area, disengage the
hydraulic power, lower implement (or if working underneath, raise and block
securely), shut off the engine, set the brakes, and remove the ignition keys.
Be certain all moving parts on attachments have come to a complete stop
before attempting to perform maintenance.
Never work under equipment unless it is blocked securely. Never depend on
hydraulic system to keep implement in raised position.
Keep all persons away from operator control area while performing
adjustments, service, or maintenance.
Always use personal protection devices such as eye, hand and hearing
protectors, when performing any service or maintenance.
