Operation Manual
-
１１
-
Chap 6 Cutter / plotter
6-1 Structure of cutter holder and items of components
Rotate the cutter holder to adjust the out-stretching length of the cutter as to
ensure that it doesn’t cut off the bottom layer of stickiness
(consists of upper and bottom layer).
1.
Cutter (diameter is 2mm)
2.
Cutter holder shell
3.
Cutter holder body
4.
Cutter-exiting staff
6-2
Installation and adjustment
1.
Before installing the cutter, you must carefully clean the cutter holder body,
the cutter and your hands. Even very slight dirt powder can affect the
rotating sensitivity. Insert the cutter into the cutter holder body with care,
then push the cutter to the bottom with a flexile plastic or rubber, but don’t
damage the blade tip.
2.
Rotate the shell of the cutter holder and make the out-stretching length of
the blade tip not larger than the thickness of the stickiness.
6-3 Plotter holder
You can use the ball-pen to plot with the given plotter holder.
1.
Rotate the lid.
2.
Install the refill with the spring.
3.
Covr the refill with the lid then rotate them into the shelf.
6-4 Installation
1.
Turn off the power.
2.
Loose the locking-screw of the cutter-bracket, then put the cutter holder or
plotter holder in the “V” breach and ensure the blade tip or refill to reach
to the plastic pressing-strip. Fasten the locking-screw clockwise at last.
3.
After turning on the machine, the tip should be raised about 1 to 2mm
away from pressing-strip.