![background image](http://html1.mh-extra.com/html/usag/447-t/447-t_operatinginstructions-and-maintenance_1063952021.webp)
447 T
DISPOSITIVO PNEUMATICO
PER SMONTAGGIO E MONTAGGIO AMMORTIZZATORI
PNEUMATIC DEVICE FOR ASSEMBLING AND
DISASSEMBLING SHOCK ABSORBERS
SWK Utensilerie S.r.l. Via Volta 3; 21020 Monvalle (VA) – Italy
Tel +39/0332/790111 Fax +39/0332/790602 Internet: www.usag.it www.usag-tools.com E-mail: [email protected]
21/28
IT
A
LI
A
N
O
E
N
G
LI
S
H
Compress the spring using the foot control lever only to release the
pressure that the spring it-self exert on the cap.
Do not compress the spring completely (see fig.5).
Remove the blocking cap form the shock absorber unscrewing the
nut. Discharge the compression of the spring and replace the old
shaft with the new one.
11.2 Assembling
For assembling make the contrary operations of the disassembling. Put the new spring in
the same position where the old one was.
Press the foot control lever in order to make
the spring stuck to the blocking cap.
Block the cap to the shaft of the shock absorber screwing the proper nut.
Now the shock absorber is mounted, use the foot control lever to release completely
the spring, then move the arms on the outside and remove the shock absorber now
reassembled thanks to the machine 447 T.
12 OPERATION ANOMALIES, CAUSES, SOLUTIONS
Operation
anomalies
Causes
Solutions
The machine does
not work
Control the
connection to the
compressed air
system
Connect the machine to
the local pneumatic
system through the quick
connection equipped
The two arms do not
run properly along
the columns
Dust and dirty on the
columns
Lubricate the sliding part of
the machine using proper
products
The piston’s shaft
after moving
forward does not
keep the position
and goes back
There is an air lack in
the cylinder
Contact customer service
to repair the cylinder
Fig. 5