3. Slide axle through
holes provided in dolly/
basket (Fig. 3).
4. Slide remaining wheel
onto axle and hammer
on second cap nut (Fig.
4).
5. Take rear dolly assem-
bly and place into slots
(on rear of tank opposite
drain) and secure with
screws provided (Fig. 5).
6. With tank drain fac-
ing you, take caster foot
marked with the letter A
(Fig. 6) and place in slot
on left side of tank also
marked with the letter
A and secure with screw
provided (Fig. 7).
7. Take caster foot
marked with the letter B
(Fig. 8) and place in slot
on right side of tank also
marked with the leter B
and secure with screw
provided (Fig. 9).
8. Insert casters into feet
by placing stem of caster
into holes provided. Ap-
ply pressure and twisting
motion until casters snap
into place (Fig. 10).
9. Return tank to upright
position.
INSTALLING THE CARRIAGE HANDLE
Stand vacuum right side
up. Place metal carriage
handle outside of tank
and under the side car-
rying handles. Be sure to
spread the ends of the
carriage handles when
assembling to prevent
damage to the tank.
Align holes of carriage handle to holes in tank
and fasten tightly with screws, washers, and
nuts provided. The sealing washer and screw
have a close fitting tolerance. Rubber side of
sealing washer should fit against inside wall of
tank.
Failure to properly install rubber washer could
result in water leakage or loss of performance.
Replace the tank cover and clamp the lid latch-
es securely.
AS810 ASSEMBLY
DOLLY, CARRIAGE HANDLE AND BASKET
ASSEMBLY FOR METAL TANKS
1. Remove head from tank and place tank up-
side down on a flat surface.
2. Place wheels on rear frame/axle assembly
with extended hub of wheel towards dolly
frame and place cap nuts on axle. Secure with
hammer.
3. Insert caster socket into front frame and se-
cure with phillips head screw.
4. Place groove in front frame into lip of tank
and position so frame is directly above inlet.
5. Position grooves of rear frame into lip of
tank and align so rear and front frames en-
gage.
6. Secure dolly frame to tank by placing ma-
chine screws up through holes in dolly frame.
Ensure head of screw is fully recessed in area
provided. After machine screw is inserted,
tighten with flatwasher and hex nut.
7. Insert caster in
caster socket and ap-
ply downward pres-
sure until caster snaps
into place, as shown in
fig.11 & fig.12.
8. Return vacuum to upright position. At-
tach carriage handle to tank by inserting bolt
through the center hole of handle and tank,
secure with nut provided. Attach side handles
with screws provided. Be sure to spread ends
of carriage handle when assembling to prevent
damage to tank.
ITEM NUMBER & DESCRIPTION
1. Cap nut
2. 8" wheel
3. Axle
4. Rear frame
5. Caster socket
6. Front frame
7.#8 x 1/2" lg. Screw
8.1/4 - 20 x 3/4" lg.
Machine screw
9.1/4" Flatwasher
10.1/4 - 20 Hex nut
11.Caster
15
Fig.9
Fig.8
B
B
Fig.7
Fig.6
A
A
Fig.4
Fig.3
Fig.5
Fig.10
Screw
Sealing washer
Carriage handle
Hex head
Locknut
Fig.12
Fig.11
E N G L I S H •
User’s manual
AS810 & AS818 manual.indd 15
28/05/15 15:34
