17
DS1083-078
If, at a later stage, it becomes necessary
to remove the cover use a screwdriver in
the indicated points.
2
2
1
1
2.3. DESCRIPTION OF
COMPONENTS
1
2
5
3
4
6
7
8
1.
STATUS LED
: LED showing the state of your
Internet connection.
fl
ashing red light
: the device is turned on in
the con
fi
guration mode;
•
steady green light
: the device has been
correctly registered with the Urmet SIP
server and is ready to forward calls to a
smartphone;
fl
ashing green light
: the device is connected
to the Internet but cannot reach the Urmet
SIP server;
steady red light
: the device is showing that
there is no Internet connection;
steady orange light
: device not enabled (no
active Wi-Fi.)
During power-on or after pressing
the PROGR/RESET key, the device
will need 50s to start up; during this
time, the LED will remain off.
2.
PROGR/RESET key
: by pressing the button
for a time
comprised between 2s and 8s
, the device
will restart in the con
fi
guration mode
(maintaining any parameters that had already
been con
fi
gured);
shorter than 2s or longer than 8s
, the
device will be restarted.
After 5 short consecutive presses
(at time intervals shorter than 1s)
the device will restore its factory
parameters and signal the event
with a
fl
ashing red/orange/green
LED light, to then switch to the
con
fi
guration mode.
3.
LAN connector
: Ethernet port for wired
connection to the home network.
4.
Jumpers to de
fi
ne the type of power supply
to the device.
Power from Bus line
(DEFAULT)
Power from local external power
supply
5.
+/- 24V terminals
: external local power supply
terminals.
Certain 2Voice system con
fi
gurations allow the
Call Forwarding Device to be powered directly
from the BUS line of the system without using
a local power supply ref. 1083/24; a few limit
examples are listed in the following table:
•
•
•
•
•
•
