Urban MilkShuttle, Operating Instructions Manual

Page: 51 / 88

Programming and calibrating
51
7. To adjust the time for agitating , press the key:
8. Press the key:
9. Use / to set the required agitating time (20 sec.):
10.Briefly press the key.
11.To adjust the break time , press the key:
12.Press the key:
13.Press / to set the required break
time (30 seconds):
14.Briefly press the key.
You can cancel the changes to the values at any time with the key.
7.3.3 Programming the start times
In this menu you can pre-program the start times. Each pre-selection key ,
and can have 2 start times assigned, one for feeding in the morning and one
for feeding in the evening. The Milk Shuttle automatically starts heating and
agitating at the specified time. This omits waiting times until the feed has been
heated.
Carry out the following steps to program the start times:
1. Switch on the Milk Shuttle with the key.
The device is in standby mode and
the start display is shown:
2. Press the key for approx. 2 seconds. If no start time is programmed, the
device automatically begins with heating and agitating.
In the display, the view switches to:
CAUTION
After creating/changing the start times, you must make sure that the power sup-
ply is
never switched on when the feed container is empty .
This could otherwise damage the heater and the agitator!
CAUTION
-
SET Agitating
00:10
SET
SET Agitating
>00:10<
+
-
SET Agitating
>00:20<
SET
SET Agitating
00:20
-
SET Break
00:15
SET
SET Break
>00:15<
+
-
SET Break
>00:30<
SET
SET Break
00:30
ESC
INFO
1 2
3
ON
08.04.1
6
10:30:32
MilkShuttle 105A31
°C/F
He
ating Break
16.3 C 00:28
Heating Agitating
16.3 C 00:28
blinking
1 sec