Urban MilkShuttle, Operating Instructions Manual

Page: 37 / 88

Operation
37
6.4 Cleaning
The Milk Shuttle must be cleaned after every use in order to clean the container
and the conveying system:
6.4.1 Milk Shuttle without dosing pump
1. Roughly wash off the inside of the container and the agitator with cold water.
2. Let the water drain.
3. Refill with water until it has covered half of the agitator propeller. If necessary,
add detergent:
- for whole milk feeding for every 4
th
cleaning
- for calf milk replacer (CMR) feeding for every 6
th
cleaning
4. Let the water heat by pressing and holding the key to start heating and
agitation. Once the required temperature is reached:
5. Switch the agitator to Level II (fast mode) and press and hold the key on
the operating panel to start the agitator.
6. If strongly soiled:
• Switch off the agitator at the motor (switch at position "0")
• Interrupt the agitating interval using the key on the operating panel
• Use a brush to preliminarily clean the inside of the container
• Switch the agitator back on (switch at position "2")
• Press to continue the agitating interval.
CAUTION
The device may not be operated if the charge condition is insufficient (battery
voltage less than 12 V). This could otherwise damage the battery!
For temperatures below 0°C , charge the battery sooner (at 12.2 V and less).
CAUTION
CAUTION
It must be ensured that cleaning is never started when the feed container is
empty .
This could otherwise damage the heater, the mixer and the dosing pump!
CAUTION
°C/F
I
0
II
START
STOP
START
STOP
START
STOP
START
STOP
START
STOP
START
STOP