Upright X Series, Service & Parts Manual

Page: 32 / 164

Page 3-4
Maintenance
3.5 - Supporting Elevating Assembly
X Series Work Platform
3.5 S
UPPORTING
E
LEVATING
A
SSEMBLY
X20N, X20W, X26N
Figure 3-5: Blocking the Elevating Assembly--X20N, X20W, X26N
I
NSTALLATION
1. Park the work platform on a firm,
level surface.
2. Verify that both Emergency Stop
Switches are ON.
3. Turn the Chassis Key Switch to
CHASSIS.
4. Push the Chassis Lift Switch to
UP, and elevate the platform
approximately 9.5 Ft. (2.9 m).
5. Rotate the Scissor Brace
towards the front, and allow it to
hang vertically over the lower
scissor pivot tube.
6. Push the Chassis Lift Switch to
the DOWN position, and gradu-
ally lower the platform until the brace rests on the lower scissor arm pivot tube.
R
EMOVAL
1. Push the Chassis Lift Switch to the UP position and gradually raise the platform until the
lower end of the Scissor Brace will clear the lower scissor arm pivot tube.
2. Rotate the Scissor Brace up and over towards the rear so that it rests on the cylinder mount,
stowed position.
3. Push the Chassis Lift Switch to the DOWN position, and completely lower the platform.
4. Turn the Chassis Key Switch to DECK.
W A R N I N G
! !
Never perform service on the work platform in the elevating assembly area while the
platform is elevated without first blocking the elevating assembly.
DO NOT stand in the elevating assembly area while deploying or storing the brace.
060571-005