2-10
LX13/41 Electric Work Platform
M
ACHINE
P
REPARATION
& O
PERATION
Section
2.10
2.10 F
OLD
D
OWN
G
UARDRAILS
This procedure is only for passing through doorways.
Guardrails must be returned to proper position before
using the machine. Refer to Figure 2-7 (single deck)
or Figure 2-8 (double deck).
Single Deck Fold Down Procedure
Figure 2-7: Fold Down Guardrails
NOTE: When performing the following proce-
dures retain all fasteners.
1. Place controller on platform.
2. Starting at the front of the platform, remove nuts,
bolts and washers from the top of the front guard-
rail. Fold the front guardrail down onto the plat-
form.
3. Close and latch the gate.
4. Remove nuts, bolts and washers from the top of
the rear guardrail. Fold the rear guardrail down
onto the platform being careful to keep gate
latched at all times.
5. Remove nuts, bolts and washers from the top of
the side guardrails. Lift up and fold one side
guardrail in so it rests on the deck. Repeat with
other side guardrails.
Erection Procedure
1. Raise side guardrails making sure each is
pushed down to secure the guardrail in the verti-
cal position.
2. Install bolts, washers and nuts between the side
guardrails, tighten securely.
3. Raise rear guardrail assembly, aligning holes and
install bolts, washers and nuts. Tighten securely.
4. Raise front guardrail, aligning holes and install
bolts, washers and nuts. Tighten securely.
5. Hang controller from front guardrail.
6. Before operating work platform check that all fas-
teners are in place and properly torqued.
Before operating machine, guardrails must be
securely fastened in their proper position.
W A R N I N G
!
!
Summary of Contents for LX31
