Upright LX31, Service Manual

Page: 23 / 120

LX13/41 Electric Work Platform 2-11
M
ACHINE
P
REPARATION
& O
PERATION
Section
2.10
Double Deck Fold Down Procedure
Figure 2-8: Fold Down Guardrails (Double Deck)
NOTE: When performing the following proce-
dures retain all fasteners.
1. Place controller on platform.
2. Starting at the front slide out deck, remove nuts,
bolts and washers from the top front corners of
guardrails. Remove the nuts, bolts and washers
from the slide out deck side guardrail midrails.
Also remove nuts, bolts and washers located at
the top of the sockets that hold the slide out deck
side guardrails to the deck. Fold the side guard-
rails down onto the platform.
3. Follow step 2 to fold the side guardrails on the
rear slide out deck.
4. Unlatch the gate so the left side guardrails can be
folded down in two separate pieces. Also remove
the nuts, bolts and washers opposite the gate
latch on the right side guardrail so it too can be
separated into two pieces.
5. Lift up and fold side guardrails in so they rest on
the deck.
6. Lift up and fold front guardrail in so it rests on the
deck. Repeat for rear guardrail.
Erection Procedure
1. Raise front guardrail making sure it is pushed
down to secure the guardrail in the vertical posi-
tion. Repeat for rear guardrail.
2. Raise side guardrails making sure each is
pushed down to secure the guardrail in the verti-
cal position, align holes and install bolts, washers
and nuts. Tighten securely.
3. Raise one of the four slide out deck side guardrail
assemblies, align holes and install bolts, washers
and nuts. Tighten securely. Repeat this proce-
dure for the other three slide out deck side guard-
rails.
4. Hang controller from front guardrail.
5. Before operating work platform check that all fas-
teners are in place and properly torqued.
Before operating machine, guardrails must be
securely fastened in their proper position.
W A R N I N G
! !