3.
Setting and Unsetting
14
CommPact User Manual
3.6.
Remote Setting/Unsetting
Remote Setting/Unsetting via SMS
You can set and unset the system remotely by sending SMS commands from a cellular
phone.
Each SMS command contains the following elements:
•
SMS Command Descriptor (up to 43 characters of free text)
•
# (separates the descriptor from the actual command)
•
User Code
•
Command ((120=Unset, 121=Full Set, 122=Part Set, 123=Perimeter Set,
124=Full + Perimeter Set, 125=Part + Perimeter Set, 200 = Set Status
∗
)
The following example shows the format of an SMS command for unsetting the system:
SMS Command Descriptor
User Code
Command
D I S A R M #
1 2 3 4 1 2 0
While the SMS Command Descriptor is optional, you must start the SMS
command with the # symbol for the system to accept the command. Don't use
"#" symbol within the descriptor text.
Set Status Reply
On receiving a Set Status request message (see command "200" above), the system
returns a status message to the sender. This message includes the system status and the
descriptor of the user or the device used to set/unset the system.
The following example shows a Set Status Reply message reporting that the system was
fully set by Master User.
F
U L
L
A R M E
D -
M A S T
E
R
U S
E
R
SMS Confirmation message
After an SMS command is executed by the system, if programmed by your
engineer, a confirmation message may be returned to your mobile phone. The
following example shows the confirmation message you receive for the sample
command from the previous section.
D I
S
A R M E D
∗
Master code is required for the Set Status command.
