45
Version 1.0
© UNIVERS
English
Menus and OSD
6
If you have problems during the search of a satellite, go into the
Installation Menu>Antenna Direction
menu and make the engine
turn until it reaches the value calculated on the scale of the engine.
Limit Set
In the case that an engine installed in a DiSEqC 1.2 Sat antenna is not able to turn
properly due to the antenna’s size, you have the possibility to increment the turn field
above the software limits.
For example, in order to adjust the western limit, go to the
Continuously Move
or
Move
Steps
options and make the engine turn with the
VOL
press button as far as the
desired western limit.
However, estimate a small safety distance for the antenna. After that, go to the
Limit Set
option with the
CH
buttons and select the
West Limit
option with
VOL
.
Then, press the
OK
button in order to store this limit.
Go to sat
This function allows you to make the engine swivel round on purpose from a stored
position to the 0 ° position. This operation may be useful if you search for a satellite which
is very near from the stored position.
Go to the
Goes to Sat
menu option with the
CH
buttons and press
OK
.
Then make your selection with the
CH
buttons and press
OK
.
The receiver will send next a command for the engine to turn to the selected position.
In the case you leave the menu by pressing
EXIT
without having stored your changes yet,
the following message will be displayed:
Select "
Yes
" with the
VOL
buttons and then press
OK
in order to store the changes.
The
EXIT
button will cancel the operation and leave the menu.
00 Ref Position
01 HotBird
02 Astra
You have changed the satellite position.
Press “ YES “ to store the changed position
or press no to cancel
Yes
No
!
