44
Version 1.0
© UNIVERS
English
Menus and OSD
6
Select now the
00 Ref Position
entry with the
CH
buttons and press
OK
again.
The receiver will then send a command to the engine to go to the “0 degree” position. Both
devices will be thus adjusted to each other.
Satellite name
Select, with the
VOL
press buttons, the satellite you wish.
Once the satellite has been found, you can start a search run directly from this entry, by
pressing
OK
.
Transponder
Select a transponder with the
VOL
buttons.
This option provides information on frequency, symbol rate and polarity.
Once you have found the satellite, you can start a transponder search directly from this
entry by pressing
OK
.
Caution:
Please test the usual satellites before trying the “exotic” ones!
Positioner
Choose <
On
> with the
VOL
buttons if you still have not done it from the
Antenna
Config
>
Setup
option.
Continuously Move
The
VOL
press buttons will allow you to send commands to the engine, for it to turn
East or West. If it is a command stored in the DiSEqC engine (Example: Astra 19,2° East),
it will turn automatically by pressing
VOL
until the engine achieves the stored
position.
However, if you press the
VOL
button for the engine to turn West, it will turn
continuously to the west until it reaches the west limit.
Move Steps
This option makes you send the command for the engine to turn east or west in a step by
step way by pressing the
VOL
buttons.
The steps width is determined under
Step size
.
You can adjust the step as you wish by making use of the
Strength
and
Quality
options.
Press the
OK
button once you have made the modifications you want.
Step Size
You can indicate here how much the engine is supposed to turn in each movement under
the
Move Steps
option.
Select the step width using the
VOL
press buttons, from step size 1 until 10.
