10
Version 1.0
© UNIVERS
English
Installation
4
The following steps assume, that ...
... the receiver is properly set up and the satellite antenna is correctly installed and aligned.
In case of eventual problems with the direction of the SAT-antenna, please read the page
42 about the antenna direction menu.
Important:
Unplug the receiver if you wish to carry out connection tasks.
Connection ...
... for connecting your receiver to the satellite antenna (or to the antenna socket at a
SMATV installation) you need a sufficiently long Sat coaxial cable suitable for digital
reception. If the F connectors are not mounted into the connecting cables yet, please
proceed to mount the connector as follows:
Finally screw the F connector carefully into the cable until the epoxy insulation reaches
the connector’s thread end.
Important:
Pay special attention not to cause a short circuit in the connector (it is a very common
mistake to leave a shield’s wire touching the inner conductor). This short circuit will make
the reception impossible.
Finally connect the cable (properly mounted) into the receiver’s IF IN connector (1)
located in the back panel.
Connecting to a TV set and a video tape recorder
In order to obtain an optimal picture quality you should use Scart connectors for both the
TV set and VCR.