10
STEP 7
Attach the actuator to the servo bracket using (2) two
#10 X .500 screws. Make sure the servo bracket is flush
with the of the top of the actuator before securing.
STEP 8
Measure 14” from the floor to the bottom of the servo
bracket to locate the placement of the actuator.
NOTE: When locating the position of the actuator, insert
the servo arm into the actuator as shown.
Use (3) three #10 x .500 screws to attach the actuator
to the unit.
STEP 8
Use a self drilling screw to attach the handle hook on
the lower right hand side of the front of the unit.
Servo Arm
Actuator
Handle Hook
ATTENTION: Use the “Thermostatically Controlled
Damper Wiring Diagram” to complete the installation.
