- 26 -
© 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
2.11 Timeout Between Decodes,
Different Symbols
Use this option in presentation mode or Continuous Bar Code Read to
control the time the engine waits before decoding a different symbol. It is
programmable in 0.1 second increments from 0.1 to 9.9 seconds. The
default is 0.1 seconds.To select the timeout between decodes for different
symbols, scan the following bar code, and then scan two bar codes from
that correspond to the desired interval,
in 0.1 second increments.
2.11.1 PDF Prioritization
Scan Enable PDF Prioritization to delay decoding certain 1D bar
codes (see Note below) by the value specified in PDF Prioritization
Timeout. During that time the engine attempts to decode a PDF417
symbol (e.g., on a US driver's license), and if successful, reports this
only. If it does not decode (can not find) a PDF417 symbol, it reports
the 1D symbol after the timeout. The 1D symbol must be in the
device’s field of view for the engine to report it. This parameter does
not affect decoding other symbologies.
Enable PDF Prioritization
Disable PDF Prioritization*
Timeout Between Decodes, Different Symbols
