P n e u m a t i c
Me t a l C i rc ul a r S a w
5 1 1 1 5 0 0 1 0 - 0 0 2 0
Translation of the original manual,
compiled: 24.02.11
511150010_20_BA_en_Version_00
Page 11 of 18
7. Replace and finger-tighten the blade retaining bolt by turning it clockwise.
8. Push in the blade lock lever and rotate the spindle by hand until the lock engages the spindle
(see fig. 3). Tighten the blade retaining bolt securely with the provided wrench and release
the spindle lock.
Fig. 3
Removing the blade
1. Disconnect tool from pneumatic supply.
2. See fig. 3. It is not necessary to remove the outer blade cover, just leave it in place.
Push in the spindle lock and using the supplied hex wrench, rotate the blade until the lock
engages the blade spindle.
3. Avoid contact with the blade teeth to prevent personal injury.
4. While holding the blade lock lever, use the provided wrench to loosen the blade retaining bolt.
Then remove it and the outer spindle flange.
5.The blade may now be carefully removed.
Adjustment depth of cut
Adjust the depth of cut so that the saw blade protrudes through the thickness of work piece.
To adjust the depth of cut:
1. Disconnect tool from pneumatic supply.
2. Lift the depth lock lever at the rear of the saw (see fig. 4)
Fig. 4
CS Unitec, Inc.
s(ARBOR
Avenue
.OR
w
ALK#4s4OLL
F
REE
:
s s
F
AX
:
s
www.csunitec.com
