P n e u m a t i c
Me t a l C i rc ul a r S a w
5 1 1 1 5 0 0 1 0 - 0 0 2 0
Translation of the original manual,
compiled: 24.02.11
511150010_20_BA_en_Version_00
Page 15 of 18
Clamp the work piece
Secure the work piece properly. The work piece should be straight and firmly clamped to avoid
possible movement and pinching as the cut nears completion. Provide adequate support for long
or wide work pieces. Confirm that the blade has come to a complete stop before removing or
securing the work piece, or changing the work piece angle. First press the valve trigger. Move the
saw forward to contact the work piece. Clamp the work piece on a rigid support, such as a bench
or saw horses. Mark the line of cut on the work piece. Be sure that the cut- off line is far enough on
the work piece to allow proper operation of the telescoping guard. Place the front edge of the saw
squarely on work piece before starting the motor. Adjust the cutting line with the sighting notch
indicator or use the rip fence. Be certain that the blade is not contacting the work piece. Press the
lock lever and the valve trigger, allow the motor to come up to full speed and move the saw forward
to begin the cut.
Caution: Keep the pneumatic hose away from the cutting area to prevent it from becoming
entangled in the work piece.
Do not force the cut. Let the saw do the cutting at the rate of speed permitted by the type of cut
and work piece. Increase feed pressure as the blade cuts through the thicker cross- sections (to
maintain minimum “sparking”). Decrease the feed pressure as the blade cuts through the thinner
cross sections.
After completing the cut, release the valve trigger and wait for the coasting blade to stop
completely before putting the saw down.
Keep tool clean
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned
with a soft damp cloth. They could possibly dissolve or otherwise damage the material. Wear
safety glasses while using compressed air.
Maintenance Instructions
A continuous and proper operation requires regular cleaning.
Attention:
Make sure that the tools is shut off and not connected to pneumatic supply, before executing
maintenance, respectively an inspection of the tool. For safety reasons and in order to guarantee a
proper functioning of the machine, repairs, maintenance and adjustment of the tool has to be done
by an authorized service centre. Only use genuine spare parts.
Our pneumatic motors are designed for an operation pressure of 6 bar (65-90 PSI).
Service life and performance of the machines are decisively determined by:
a) The air purity
Blow the air hose clear before connecting it to the machine. Install dirt and water
separator upstream of the machine, if it is not possible to prevent the formation of rust
and water condensation in the air distribution lines.
b) The lubrication conditions and maintenance
see „Maintenance of pneumatic tools“
CS Unitec, Inc.
s(ARBOR
Avenue
.OR
w
ALK#4s4OLL
F
REE
:
s s
F
AX
:
s
www.csunitec.com
