P n e u m a t i c
Me t a l C i rc ul a r S a w
5 1 1 1 5 0 0 1 0 - 0 0 2 0
Translation of the original manual,
compiled: 24.02.11
511150010_20_BA_en_Version_00
Page 10 of 18
OPERATION INSTRUCTION
Important:
An appropriate blade must be mounted to the machine before operating. Refer to the section of
this manual: „Installing the blade“.
Cutting
- Check oil level
- Equip saw with the appropriate saw blade
- Connect pneumatic hose (Before connecting, it is recommended to blow out the hose and thus
remove impurities)
- Press sensor button and actuate valve
- Start cutting
After finishing the cutting work
- Shut valve
- Shut compressed air supply and disconnect air hose
- Clean saw
- Check oiler
Installing the blade
1. Disconnect tool from pneumatic supply
2. Remove any accumulated debris in the guards and around the spindle.
3. Check the lower retracting blade guard to ensure that it is in working
4. Clean the inner spindle flange. Orient the flange so that the correct bore size faces the blade
and place the new blade on the spindle, making sure that the teeth point forward. (If in doubt of
the orientation of the blade, refer to the legend cast into the lower retracting blade guard.)
5.
Note:
Only use original Tanitec saw blades.
6. Place the outer spindle flange on the spindle with the flat side towards the blade (see fig. 2)
Abb. 2
Fig. 2
CS Unitec, Inc.
s(ARBOR
Avenue
.OR
w
ALK#4s4OLL
F
REE
:
s s
F
AX
:
s
www.csunitec.com
