P n e u m a t i c
Me t a l C i rc ul a r S a w
5 1 1 1 5 0 0 1 0 - 0 0 2 0
Translation of the original manual,
compiled: 24.02.11
511150010_20_BA_en_Version_00
Page 12 of 18
3. Raise or lower the saw base until the blade extends the desired depth below the base. (See the
scale and pointer cast into the main body casting)
4. Press the depth lock lever down firmly, locking the saw in the selected position.
Adjustment of bevel angle
Disconnect from pneumatic supply. To adjust the bevel angle, refer to the bevel gauge on the
base. There are markings for different angles from 0 to 45 degrees. To adjust the bevel angle:
Loosen the bevel lock knob (see fig. 5) and the smaller knob at the rear. Lift the bevel lock knob
out of the slot and rotate the base to the desired angle. The most commonly used angles each
have an individual slot.
Fig. 5
Simply drop the bevel lock into the slot and tighten. If other angles are needed, tighten the bevel
lock knob to hold at the desired position. Then tighten the smaller knob at the rear of the base.
How to use the sighting notch
To aid in free- hand cutting, a sighting notch is located at the front of the base (see fig. 6).
Fig. 6
Align the cutting line on the work piece with the sighting notch. Make the cut. Use the right-hand
notch (between the two marking dots) for straight cuts and the left- hand notch (located below the
rivet) for 45- degree bevel cuts.
CS Unitec, Inc.
s(ARBOR
Avenue
.OR
w
ALK#4s4OLL
F
REE
:
s s
F
AX
:
s
www.csunitec.com
