P n e u m a t i c
Me t a l C i rc ul a r S a w
5 1 1 1 5 0 0 1 0 - 0 0 2 0
Translation of the original manual,
compiled: 24.02.11
511150010_20_BA_en_Version_00
Page 13 of 18
Starting and stopping tool
Make sure that the operation pressure of the supply line conform with the specification – 6 bar –
and the valve trigger is in 0-position. To start the machine first press safety lock lever and then the
valve trigger, to start the motor. Release the valve trigger to stop the motor (see fig. 7).
Fig. 7
Removing chips
This dry cut metal saw has an internal chip collector. When the chip collector is full, the chips must
be cleared. To do this, first shut down and disconnect from power supply.
The outer blade cover lock knob has a bayonet lock thread (see fig. 8)
Fig. 8
To remove cover, turn knob anti-clockwise while pushing in against the spring tension. Then lift
cover away. Recently- cut chips can be very hot. Take care when removing the cover to keep the
chips or shavings away from your hands or other body parts. Do not throw hot debris where paper
or other flammable materials are located. To replace the outer blade cover, line up tang with slot
and push in against the spring while turning clockwise.
Ensure that the cover is properly seated.
CS Unitec, Inc.
s(ARBOR
Avenue
.OR
w
ALK#4s4OLL
F
REE
:
s s
F
AX
:
s
www.csunitec.com
