P n e u m a t i c
Me t a l C i rc ul a r S a w
5 1 1 1 5 0 0 1 0 - 0 0 2 0
Translation of the original manual,
compiled: 24.02.11
511150010_20_BA_en_Version_00
Page 14 of 18
How to use rip fence
Using the rip fence will provide more accurate straight cuts than by cutting free- hand.
For installation, disconnect tool from pneumatic supply, then insert the rip fence in the mounting
slots in the base (see fig. 9)
Fig 9
Select the desired cut width on the cutting guide and tighten the 2 thumb screws to lock.
Lower retracting blade guard
The lower retracting blade guard is a safety device important for your protection. Every time you
use the saw, make sure that the guard rotates freely and returns quickly and completely to its
closed position. Before each use, remove any accumulated chips or shavings from the area around
the hub of the guard.
Do not lubricate this area.
The hub has a dry film lubricated surface that does not need oiling. Never block or wedge the
blade guard in the open position. Never use your saw, if the blade guard is not in working order. If
blade guard movement is sluggish or if binding exists, return the saw to your nearest authorized
service centre for repair.
How to use the tool
Attention:
To reduce the risk of injury, only use original Tanitec saw blades, which are appropriate for this
machine. Do not use saw blades of a different type.
Effective control of this powerful saw requires two- handed operation for maximum protection.
Support the work properly and to hold the saw firmly with both hands to prevent loss of control
which could cause personal injury.
Always hold the side handle with the left hand and the rear handle with the right hand for proper
hand support of the saw.
The bottom of the saw is placed on the work piece; the saw blade does not touch the work piece.
Orient the line of cut. The required speed of the blade has to be achieved, before starting the cut.
Wearing goggles, a dust mask and ear protection during use is compulsory.
Do not use cutting fluids or lubricants on the blade.
CS Unitec, Inc.
s(ARBOR
Avenue
.OR
w
ALK#4s4OLL
F
REE
:
s s
F
AX
:
s
www.csunitec.com