1.Temperature units (°F or °C)
2.Indoor Temperature display
3.Indoor temperature HI record data
4.Indoor temperature HI icon
5.Indoor temperature LO record data
6.Indoor temperature LO icon
7.Indoor humidity HI record data
8.Indoor humidity HI icon
9.Indoor humidity LO record data
10.Indoor temperature LO icon
11.CH3 temperature HI record data
12. CH3 temperature HI icon
13. CH3 temperature LO record data
14. CH3 temperature LO icon
15. CH3 humidity HI record data
16. CH3 humidity HI icon
17. CH3 humidity LO record data
18. CH3 humidity LO icon
19.Humidity unit (%)
20. CH3 humidity display
21.Channel 1,2,3 indicator
22.
Channel 1 humidity comfort icon
23.Channel 1 humidity change indication
24. Reception icon
25.Channel 1 temperature display
26. Battery low voltage prompt
27.WIFI network
28.Min/Max record mode
29.24hour for clear
30.Weather tendency indicator
31.Time Alarm 1 and Alarm 2
32.Time SYNC
33.Time and date
2.3.2 Display Console Set Up
Note: The sensor array must be powered and updating before powering up the console, or the
console will time out searching for the sensors. Power the console last.
Make certain the weather station sensor array is at least 3m away from the console and within
30m of the console. If the weather station is too close or too far away, it may not receive a proper signal.
Remove the battery door on the back of the display, as shown in Figure 3. Insert three AAA (alkaline or lithium)) batteries
in the back of the display console. The display will beep once and all of the LCD segments will light up for a few seconds
to verify all segments are operating properly.
Note:
The character contrast is best from a slightly elevated viewing angle.
Figure 3
Replace the battery door, and fold out the desk stand and place the console in the upright position.
The unit will instantly display indoor temperature, humidity and time. Channel1-3 temperature and humidity will
update on the display within a few minutes. Do not Press any menu buttons until the Channel1-3 transmitters report
in, otherwise the Channel1-3 sensors search mode will be terminated. When the Channel1-3 transmitters data has
been received, the console will automatically switch to the normal mode from which all further settings can be
performed.
