Unipulse F350, Operation Manual

Page: 43 / 115

30
4 CALIBRATION PROCEDURE
30
CALIBRATION P
R
OCEDURE
Chapter
4
⑥
b.Actual load calibration
Apply an actual load, and register the value of the actual load (rated capacity value).
≪ Setting value ≫
-19999
～
19999 (except 0)
By performing actual load calibration, the setting value of equivalent input calibration becomes the
sensor output value (mV/V) of the time when it was executed. The load with which actual load
calibration was performed can be confirmed. However, it stays unchanged when an error occurs.
◇
Actual load calibration setting method
(Example: ch1 actual load calibration)
1.
Select setting mode 4.
Press
→
three times.
2.
Set "Actual load" of the sensor.
Press four times. ⇒ "Actual load calibration"
is displayed.
* For performing actual load calibration on ch2,
switch with .
Enter a setting value input state with , and the
highest digit blinks. (Initial value: 100.00)
Check the capacity of the actually-applied load, and
input the value with .
* For inputting a negative sign, press .
Move to the lower digits with .
Recheck that the load is properly applied on the sub display (ch2 side), and press
to validate it.
3.
Actual load calibration is executed.
If actual load calibration is executed normally, a
message as shown on the right-hand side is displayed.
If actual load calibration is not executed normally, the
alarm sounds and an error is displayed.
4.
If actual load calibration is executed normally, you will
go back to the setting item select state.
Ch1 Ch 2
H I LO H I LO
FNC
H I
Ch1 Ch 2
OK LO PEAK HOLD
H I LO H I LO
H I
Ch1 Ch 2
OK LO PEAK HOLD
H I LO H I LO
Selected ch display
H I
Ch1 Ch 2
OK LO PEAK HOLD
H I LO H I LO
H I
Ch1 Ch 2
OK LO PEAK HOLD
H I LO H I LO