UNIPRO – The original Laptimer
41
Display setup
The display is divided into an upper and lower part. In the display set-up you can define which
values you want to show in the lower part during the race. The upper part of the display will
always show RPM, Lap number and lap time. You can see more about this under “Running mode”.
SET LEFT AND RIGHT SIDE OF THE LOWER PART
Choose which information you want to see in the lower left
side of the display during race (in running mode). Depending
on the options enabled, you can choose between, Speed,
RPM, Temp 1, Temp 2, Temp 3 or none. Use
and
to choose the information you want to see. If you want to
see the hidden information during race, you can see them by
pressing
Use the same procedure for setting up the information shown in the lower right side of the
display.
EXAMPLE WITH CHOSEN INFORMATION
This is an example of the display in running mode
In this example Speed is chosen to be shown in the lower left
side, and TEMP 1 is chosen to be shown in the lower right
side.
Minimum and maximum time between two trigs (retrig delay)
LOW DELAY
If you use a Loop or IR receiver, you can choose a minimum delay from one trig to the next. This
is the minimum time allowed between two trigs. This is primarily used if an IR transmitter can
reach across the track and then trigger the Laptimer more than once on the same Lap.
