UNIPRO – The original Laptimer
38
SPLITS WITH MAGNET STRIPES
If the track has more than one magnet stripe, it is possible to use the rest as split points. When
you have made a correct stripe setup, as mentioned above, you just need to set the Laptimer to
use the stripes as split points. The only problems are that you may not have enough split points,
or you may want to have the split points in different places. You can solve these problems by
using the wheel sensor to set the split points.
Defining the split points with magnet stripes
Make sure, that you have downloaded all data from the Laptimer before changing the
split points. All laps will be cleared when you change the split points.
Press
until you get to the split point viewing screen.
Then press
to go to the split point editing screen.
Press
until you get to the split magnet screen. Then
press
to leave the editing screen, and save the setup.
UNDO CLEAR SPLIT POINTS!
If you by accident clear all laps by changing the split points you can undo the action this way:
1.
Turn the Laptimer off by pressing
down for 3 seconds.
2.
Press and hold down
while pressing
once.
3.
When the display turns on, let go of the
and you will be in Undo mode.
4.
Use
or
to change between YES and NO.
5.
Leave the text on YES and press
to undo the action. The display will now turn of, and
you are ready to start all over again.