UNIPRO – The original Laptimer
45
ENGINE, RPM AND SPEED MEASUREMENT SETTINGS
You can set the engine stroke between 1 and 8. RPM delta is
the number of engine revolutions you want to have in the
intervals if you use the shift light function. In this screen you
can also set the number of magnets on the speed sensor disc
to a different number than 6, which is the standard number
of magnets on the Unipro sensor disc. Use
and
buttons to find the setting you want to change. Use
to
choose the desired setting, and use
and
to change the value. Confirm the chosen
value with
and you can move on to the next setting.
LAPTIMER SETUP – COMMUNICATION
Typical connection to the outside is either IrDA (infrared) or
USB. If you set the Laptimer to use IrDA, it will go to PC
mode after leaving pit mode. If it is set to use USB, it
changes directly to PC mode when the USB cable is
connected.
You use IrDA to send the data to our handheld Data Analyser
and USB to send data directly to a PC.
For all editing in the Laptimer setup screen: Use
and
buttons to find the setting you
want to change. Use
to choose the desired setting, and use
and
to change the
value. Confirm the chosen value with
and you can move on to the next setting.
LAPTIMER SETUP - LED INTENSITY
The Laptimer has 5 ultra bright LED lamps at the top. Two green, 1 yellow and two red. You
can adjust the intensity of the LEDS on a scale from 1 to 25. Even at full intensity, the LEDs
use very little power, so it will not affect the battery life considerably.
LAPTIMER SETUP - TEMPERATURE
You can choose between temperature readout in Centigrade or Fahrenheit.
LAPTIMER SETUP - SPEED TYPE
You can choose between speed and distance readout suitable for your country. If you choose
EU the readout are in meters and kilometers. If you choose US the readout are in inches and
miles.
LAPTIMER SETUP - OFF TIME
In this screen you can set the time to go before the Laptimer is turned off automatically.
