51
Weak and hard to read text
The contrast is set too low.
• Adjust the contrast to a higher value.
One of the temperatures do not show up
in run mode
The sensors are not detected at startup.
• Contact your dealer to order a new
button as a spare part.
Unstable data values in run mode
Excessive noise from the ignition system.
• Change to a noise reduced spark plug.
• Mount a ferrit bead on the cylinder plug
sensor cable (contact Unipro).
• Run the ignition wire as far away from
the other cables.
UniGo is not turning on
Battery might be empty.
• Press and hold the two
right
buttons for
at least 10 seconds.
• Charge the battery.
The gear indicator is not working in run
mode 2
The number of gears is not set correctly.
• Set the correct number of gears and then
go through the learning process.
No temperature shown when using a
splitter
A wrong splitter is used.
• You need to use the
gray
splitter. A
black splitter cannot be used for the
temperature sensors.
We expect a smooth and pleasurable experience when using
UniGo.
If you have any problems, either with the setup or with daily use,
please check the following pages for suggested solutions.
If you don’t find the answer to the problem here, please contact
your Unipro dealer for further assistance.
T r o u b l e -
s h o o t i n g
Troubleshooting
51
Summary of Contents for 03-05-001
