Unipro 03-05-001, User Manual

Page: 28 / 56

28
Setup mode
C o n f i g u r i n g
t h e L a p t i m e r
SENSORS SETUP
Text missing.
FLEX INPUT
It is possible to connect a sensor directly to
the Flex connector. There is not limitation
when a single sensor is connected directly and
there is a wide selection of analog, digital and
”intelligent” sensors. If more than one sensor
is to be connected, please select ”Splitter”. The
splitter is an optional accessory that makes it
possible to connect two different sensors to the
Flex connector.
SPLITTER #
If the Flex input is set to ”Splitter” you will see
”Splitter #1” and ”Splitter #2” lines. Here it
is possible to select different sensors to each
input, but not all combinations are possible.
It is not possible to connect two intelligent
sensors like Lambda and IR Box at the same
time. The intelligent sensor need to be con-
nected to Splitter #2 and then a simple sensor
to Splitter #1.
FLEX INPUT VALUE
Text missing.
SPLITTER # VALUE
Text missing.
FEEDBACK SETUP
The feedback menu contains all the settings
related to the feedback on UniGo.
WARNING LEDS MENU
The 5 LEDs are all programmable. This is done
from the warning LED setup menu. There is
one menu for each warning LED.
Warning LED menu. LED blinking at the
same time.
When moving around in the setup menu, the
corresponding LED will blink to make it easy to
identify each LED. When selecting a LED you
will get to the sub-menu with all the settings
for that specific LED.
Simple setup of one warning LED.
The setup of a warning LED consist of several
settings. Here is a short explanation of each
setting.