Unipro 03-05-001, User Manual

Page: 31 / 56

31
Setup mode
C o n f i g u r i n g
t h e L a p t i m e r
UNIGO SETUP
The UniGo menu contains all the settings
related to the UniGo.
RUN MODE SCREENS
The different run modes have different number
of data fields. All of them are configurable.
This is done from the ”screen setup” screen.
Setup run mode screens. Run mode 2
shown here.
Move around between the different data fields
with the and
up ( ) and down ( ) buttons.
The active data field is clearly marked with a
rectangle around it. To change the channel,
simply press the
ok
button ( ) to bring up the
channel select popup.
Select the channel from the popup window.
All available channels are listed including the
not so typical ones like “engine timer” and
“none”. Accept the new channel by pressing
the
ok button ( ).
LCD CONTRAST
Here you can set the screen contrast - that is
the contrast between the screen and the text /
numbers on the screen.
The contrast can be set to a value between
-15 and +15. You will see the contrast change
when adjusting the value.
BACKLIGHT BRIGHTNESS
The intensity of the display’s backlight can be
changed from 0% (off) to 100%. The backlight
use a lot of power when turned on, so please
use as low a setting as possible. When the
Laptimer is out in the sun, the backlight is not
visible at all and it can even make the contrast
worse.
BACKLIGHT OFF TIME
To save battery power, the backlight can
automatically be turned off. If the Laptimer is
not active in run mode, and the buttons are
not pushed, the backlight will turn off after
some time. This time and be set between 0:30
and 30:00 minutes and always on.
If the backlight is automatically turned off, the
Laptimer still reacts to button pushes, but the
backlight is turned on at the same time.
AUTO TURN OFF TIME
When no buttons are pressed and the Laptimer
is not detecting any signals from RPM, speed
and the trigger it will automatically power
off to save the battery. This time can be set
between “always on” and 30 minutes in steps
of 30 seconds. If set to “always on” it will
never turn off.
SET TIME
The time and date is normally set automatically
by the GPS signal. Each time UniGo gets a GPS
lock, it will adjust the time and date to the
very precise time received by the GPS receiver.
When there is no GPS signal, the internal
clock will continue to run, even when UniGo
is turned off. But if you want to manually set
the time, this can be done from this collapsed
menu.
Hour: Enter the hour of the day.