Installation
Sageon II 200A (N+1) Power Distribution System
PM990-5202-200, Rev. 6
2-16
6 / 152
2.5 / 64
1 / 25
Connector
4-pin
Dimensions are
inches / mm.
C
D
0003
9a
Direction of Positive Current
Flow with Batteries Charging
Top View
Side View
FIGURE 2-9 TYPICAL BATTERY CURRENT TRANSDUCER
TABLE 2-5 BATTERY CURRENT TRANSDUCER CONNECTIONS
Battery Current Transducer
Battery Distribution Module Board
1
X22
2
X18
3
X17
4
X12
2.10 SAGEON BATTERY MONITOR (OPTION)
The UNIPOWER Sageon battery monitor (SBM) is an add-on system for the Sageon 200A Control Unit
(SCU). It is used to monitor individual cells of a battery during float or equalization operation, or during a
discharge. Each SBM unit is capable of monitoring up to 24 cells or monoblocks. Up to four SBM units
can be used to monitor up to 4 battery strings of 24 cells or monoblocks each.
The cell voltages can be viewed in real time when the SCU is connected to a PC. The Sageview software
that is running on the PC can display the cell voltage data in various convenient formats to ascertain the
state of health of batteries.
In addition to the real time or historical representation of the data on Sageview, the cell voltages can also
be observed in real time on the SCU display.
In the event that the battery behaves in a way that is less than ideal during a test or actual discharge, a
number of pre-programmed parameter levels are used to generate alarms. Alarms are annunciated on the
SCU front panel by a LED and screen message and remotely via voltage free contacts or via the USB
communications port that can connect directly to a PC locally or remotely via a modem or ethernet.
Refer to the Sageon Battery Monitor Manual (PM990-4209–00) for detailed information.
