Setting Up Network Interfaces
Sageon II 200A (N+1) Power Distribution System
PM990-5202-200, Rev. 6
8-4
Note:
Telnet is disabled by default in Windows 7/Vista. Enable telnet by following these
steps:
1.) Click Start
2.) Control Panel
3.) Programs and Features
4.) Turn Windows features ON/OFF
5.) Check Telnet Client
6.) Click OK
4. Finally, open a Telnet connection to port 9999, and press Enter within three seconds to
go into Setup Mode. If you wait longer than three seconds, the unit will reboot.
telnet 192.168.0.97 9999
5. Set all required parameters
Note:
The IP address you just set is temporary and will revert to the default value when
the unit 's power is reset unless you log into the unit and store the changes permanently.
Refer to the chapter on configuration for instructions on permanently configuring the IP
address.
Lantronix, Inc, 2002, all rights reserved, used herein by permission from
Lantronix.
8.2.3 Configuring the Unit
The following section is excerpted from Lantronix "Embedded Integration Kit" Revision D
06/03/02, Part Number 900-226.
You must configure the Lantronix Interface so that it can communicate on a network with
Sageon CSU and communicate with the Sageon CSU unit via the internal serial port.
The unit’s configuration is stored in nonvolatile memory (NVRAM) and is retained
without power. You can change the configuration at any time. The unit performs a reset
after the configuration has been changed and stored.
8.2.3.1 Using a Telnet Connection
To configure the unit over the network, establish a Telnet connection to port 9999.
1. From the Windows Start menu, click
Run
and type the following command, where
x.x.x.x is the IP address and 9999 is the unit’s fixed network configuration port number.
telnet x.x.x.x 9999 (Example: telnet 192.168.100.123 9999)
Note: Be sure to include a space between the IP address and 9999.
2. Click
OK
.
3. The Lantronix Universal Device Server window displays.
*** Lantronix Cobox Universal Device Server ***
Serial Number 1297-041 Software Version V03.9 (000211)
Press Enter to go into Setup Mode
4. To enter the Setup Mode, you must press Enter within 3 seconds.
