Uniphos 500DT, Instruction Manual

Page: 18 / 33

18 of 33
Table: 03 Prompts on LCD/OLED in Setting mode (Password=0003)
Sr.
No. Display
prompts Comment
1 Set Time
HH:MM:SS
To set the Time. Key K2 is used to
increment the digit where the cursor is
positioned and key K1 is used to shift
the cursor to the next (towards left)
position. After the last digit,
blinking cursor disappears, press K2 to
accept changes and go to the next
prompt.
2
Set Date
DD/MM/YY
To set the Date. Key K2 is used to
increment the digit where the cursor is
positioned and key K1 is used to shift
the cursor to the next (towards left)
position. After the last digit,
blinking cursor disappears, press K2 to
accept changes and go to the next
prompt.
3 RLY_SEL
xxxx
To activate / deactivate the relay
output. XXX can be HI or LO . Key K1 is
used to change it and K2 is used to
confirm the change and go to the next
prompt.
4
OXY_SEL
xxxx
To activate the relay output & alarm
logic for Oxygen gas selection. XXX can
be YES or NO . Key K1 is used to change
it and K2 is used to confirm the change
and go to the next prompt.