UNION Instruments GmbH
INCA Analyzer Series
– Instruction Manual
Appendix
Page 59 of 59
9.2.8
SD card errors
Error code
Display description
Full description
0x0700
SDCARD POWER ON CMD0
Power on command failed
0x0701
SDCARD INITIALIZE CMD1
Initialize command failed
0x0702
SDCARD READ SECT.
SEND CMD
Read section from card failed
0x0703
SDCARD READ SECT.
START BYTE
Read section start byte failed
0x0704
SDCARD WRITE SECT
SEND CMD
Write section to card failed
0x0705
SDCARD WRITE SECT BUSY
Timeout occurred for writing to card
0x0710
SDCARD FILE IO MOUNT
File mount error
0x0720
SDCARD FILE IO OPEN
File open file error
0x0730
SDCARD FILE IO READ
File read error
0x0740
SDCARD FILE IO WRITE
File writ error
0x0750
SDCARD FILE IO SEEK
File seek error
0x0760
SDCARD FILE IO UNLINK
File delete error
9.2.9
H-Bus errors
Error code
Display description
Full description
0x0801
HBUS CRC
Error occurred when check CRC16 of H-Bus communication
0x0802
HBUS UNKNOWN
COMMAND
Unknown command detected on H-Bus
9.2.10 Event messages (not defined as errors)
Error code
Short description
Full description
0x5000
EVENT BOOTING SYSTEM
System was booted up
0x5001
EVENT ENTER WARMUP
System entered warm-up
0x5002
EVENT TIME FORWARD
Daylight saving active time was set forward
0x5003
EVENT TIME BACKWARD
Daylight saving active time was set backward
0x5004
EVENT ENTER ERROR
Message is stored when entering the error state
0x5005
EVENT CALIB STARTED
Event written when calibration is started
--- currently not used ---
0x5006
EVENT CALIB FINISHED
Event written when calibration is finished
--- currently not used ---
