7.4 Loading Roll Stock
1. Pull the outer roll stock alignment guide down
towards the outside of the Unit.
3. Lift the outer roll stock guide to its upright
position.
4. Center the roll using the support/alignment
guides. Reference the alignment marks on the
back or front side of the roll stock support arm.
5. With the thermal printing surface up, insert the
stock between the right and left guide until
r (TOF) and
the print motor starts advancing.
6. The stock will automatically be pulled in by the
platen and detected by the Present Sensor (PS).
7. The stock is now loaded and ready for printing.
2. Place the roll onto the support arm.
Outer Roll Stock
Alignment Guide
Alignment
printing
surface out
detected by the Top Of Form senso
Marks
Thermal
Wound Out Stock Roll Shown
ET6000 Operator’s Manual
71U-1415-100K; REV E
Page 24 of 38
