56
To operate from a remote location, use any touch-tone telephone, and follow these steps:
1. Call your telephone number and wait for the system to answer. If the answering system is off, it will answer
after about 10 rings and sounds a series of beeps.
2. During the greeting or the beeps (if answering system is off), press 0 and enter your security code/PIN within
two seconds (see
Setting a Security Code or Personal Identification Number (PIN)
on page 51).
3. The answering system announces the current time and the number of messages stored in memory. You hear
"To play incoming messages, press zero-two. For help, press one-zero" followed by a beep.
4. Enter a remote command from the chart below. You have 15 seconds to enter the first command; after the first
command, you have two seconds to enter each command.
Command Function
Command Function
[0]
then
[1]
Repeat a message*
[0]
then
[6]
Answering system on
[0]
then
[2]
Play incoming messages
[0]
then
[7]
Memo record start/stop
[0]
then
[3]
Skip a message
[0]
then
[8]
Greeting message record start/stop
[0]
then
[4]
Delete a message
[0]
then
[9]
Answering system off
[0]
then
[5]
Stop operation
[1]
then
[0]
Help
* If you press
[0]
then
[1]
in the first four seconds of a message, the system skips to the previous message.
If you press
[0]
then
[1]
after the first four seconds of a message, the system repeats the current message.
5. When you finish, you will hear intermittent beeps indicating that the system is in the command waiting mode.
Enter another command from the chart within two seconds.
6. Hang up to exit the system. The answering system automatically returns to its normal standby setting.
