![background image](http://html1.mh-extra.com/html/unicarriers/fd160-2/fd160-2_operation-and-maintenance-manual_3719821131.webp)
PERIODIC INSPECTION
4-32
REPLACING TORQUE CONVERTER INLINE FILTER
ELEMENT
(AT 200 HOURS OF OPERATION FOR FIRST TIME
ONLY)
TORQUE CONVETER
INLINE FILTER
1) Put an oil receiving pan under the filter and turn the filter case
to remove it.
2) Drain oil from the filter case into the pan.
3) Install a new filter cartridge.
4) When only the filter is replaced with a new one, add oil into the
filter case.
CHANGING TORQUE CONVERTER OIL AND
CLEANING INSIDE TORQUE CONVERTER
DRAIN PLUG
Put an oil receiving pan under the filter and remove the drain plug
of the transmission to drain the torque converter.
Remove the suction pipe and take out the suction strainer. Clean
it.
After completing the above step, add new oil into the torque
converter through the oil fill port (3 months or 600 hours of
operation for the first time only).
After changing the oil, start the engine and let it run at low rpm
for a few minutes to clean inside the torque converter. Drain the
torque converter, add new oil again and let the engine run at low
rpm. Repeat this procedure until oil drained through the drain plug
is clean.
Summary of Contents for FD160-2
