22
REQUIRED MATERIAL
Flat steel bar thickness 4.8 mm, max. width 50.8 mm.
1 flat steel rod 263.5 mm long
1 flat steel rod 63.5 mm long
BENDING PROCEDURE
Make the letter "L" according to instructions below.
Final steps
Place the long piece (3" = 63.5 mm long) to a position
as shown on the picture and stitch weld it in place.
Grind and sandblast all sharp edges.
REQUIRED MATERIAL
Flat steel bar thickness 4.8 mm, max. width 50.8 mm.
1 flat steel bar 355.6 mm
1 flat steel bar 76.2 mm
BENDING PROCEDURE
Make the letter "C" according to the procedure described earlier.
Bend
Slide the long piece (76.2 mm) to the machine all the way
to the chalk mark and perform 90° angle bend. Check the
angle. Remove the stud that holds the sharp-angle die in
place. Remove it from the machine.
Final steps
Place the long piece (76.2 mm long) to a position as
shown on the picture and stitch weld it in place.
Grind and sandblast all sharp edges.
25.4
mm
19
Bend No. 5
Slide the work piece to the mark No. 5 (pic. E) and perform 45° angle bend. Check the angle.
Bend No. 6
Slide the work piece to the mark No. 6 (pic. F) and perform 45° angle bend. Check the angle.
Remove the stud that holds the sharp-angle die in place. Remove it from the machine.
Final steps
Grind and sandblast all sharp edges.
REQUIRED MATERIAL
Flat steel bar thickness 4.8 mm, max. width 50.8 mm.
1 flat steel rod 317.5 mm long.
1 flat steel rod 152.4 mm long
BENDING PROCEDURE
On the long piece (length 317.5 mm), make the bend markings as seen on the picture.
152.4 mm
31.8
mm
76.2
mm
31.8
mm
76.2
mm
