30
Bend No. 7
Slide the work piece to the mark No. 7 (pic. G) and perform 41° angle bend.
Check the angle.
Bend No. 8
Slide the work piece to the mark No. 8 (pic. H) and perform 45° angle bend.
Bend No. 9
Turn the piece around (see picture. I).
Remove the sharp-angle die stud to make room for the work piece,
slide the work piece in the machine and place the stud back again.
Slide the work piece to the mark No. 9 and perform 45° angle bend. Check the angle.
Bend No. 10
Turn the work piece around again (pic. J) and move it to the mark No. 10 and perform 45° angle bend.
Inspect the angle. Also make sure that the lower and the upper part of the letter "S" are parallel to
each other.
11
•
Using the short connecting stud mount the 38.1 mm (1 1/2") die in the handle hole 2).
•
Using the long connecting stud, mount the stopper cube (as shown on picture A).
•
Place the flat steel in your machine so the end of the work piece extends 44.5 mm beyond the die on the
centre stud (see picture B).
•
Fasten the work piece to the stopper cube wit self-locking pliers.
•
Perform the first bend. Turn the handle till the handle die leaves the end of the material.
•
Remove the stopper cube and both dies. Change the handle connection and fix the sharp-angle die (see picture C).
•
Slide the work piece as far as possible (against the centre stud).
•
Place the stopper stud in the sixth hole of the ring (counting from the closed ring end clockwise).
•
Turn the handle and perform the second bend at a distance of around 3.2 mm form the stopper stud.
Double holder
REQUIRED MATERIAL
To manufacture a pipe holder with inner diameter of 25.4 mm (to
hold a pipe with outer diameter of 25.4 mm) use flat, hot-rolled steel
bar with length 165.1 mm and with cross-section 25.4 x 4.8 mm.
NOTE:
if you are to make similar holder with different dimensions,
you must first test, which die size and what position of the cube
best fits your design.
Using the long connection stud, connect the handle brackets
and rings through their centre hole (for the centre stud).
Place 25.4 mm (1" ) die on the centre stud.
•
Using the short connecting stud mount the 38.1 mm (1 1")
die in the handle hole 2).
•
Using the long connecting stud, mount the stopper cube
(as shown on picture. A).
•
Place the flat steel in your machine so the end of the work
piece extends 44.5 mm beyond the die on the centre stud
(see picture. B).
•
Perform the first bend. Turn the handle till the handle die leaves
the end of the material.
Turn the work piece around according to picture C and place it in
the machine so the other end is extending beyond the die on the centre stud by 44.5 mm.
Position 2
1
3
/
4
" - 44.5 mm
Die
38.1 mm
(1
1
/
2
")
Die 25.4 mm (1")
Non-moveable
stopper
