Ultratec SUPERPRINT PRO80, Using Manual

Page: 76 / 82

FCC information
This equipment generates and uses radio frequency
energy and if not installed and used properly, that is,
in strict accordance with the manufacturer’s
instructions, may cause interference with the radio
and television reception. The Superprint Pro80 LVD has
been tested and found to comply with the
specifications for a Class B computing device in
accordance with the specifications in Subpart J of Part
15 of the FCC Rules. These rules are designed to
provide reasonable protection against radio frequency
interference in residential installations.
There is no guarantee that interference will not occur
during use. You can determine if this equipment
causes interference to radio or television reception by
turning the Superprint
Pro80
LVD on and off while
the television or radio is on.
If this equipment does cause interference the user is
encouraged to try to correct the interference by one or
more of the following measures:
– Reorient the radio or television receiving antenna.
– Move the Superprint
Pro80
LVD further away
from the radio or television.
– Plug the Superprint
Pro80
LVD into a different
outlet so it is on a different branch circuit than
the television or radio.
– If necessary, consult an experienced
radio/television technician or the manufacturer for
additional suggestions.
The user may find the following booklet prepared by
the Federal Communications Commission helpful:
Interference Handbook. This booklet is available from
the Superintendent of Documents, U.S. Government
Bookstore, 310 W. Wisconsin Ave., Suite 150,
Milwaukee, WI 53203, (414) 297-1304 (voice).
This equipment complies with Part 68 of the Federal
Communications Commission (FCC) rules for the
United States.
The telephone jack used on the Superprint
Pro80
LVD
complies with FCC Part 68, Subpart F rules and
regulations and is an RJ11C.
A label is located on the underside of the Superprint
Pro80
LVD containing the FCC registration number
and the Ringer Equivalence Number (REN). You
must, upon request, provide the following
information to your local telephone company: USOC
Jack Type: RJ11; REN:0.6B.
Should you experience trouble with this telephone
equipment, please contact:
Ultratec National Service Center
5901 Research Park Blvd.
Madison, WI 53719
email: service@ultratec.com
The REN is used to determine the quantity of devices
which may be connected to the telephone line.
Excessive RENs on the telephone line may result in
the devices not ringing in response to an incoming
call. In most, but not all, areas the sum of RENs
should not exceed five (5.0). To be certain of the
number of devices that may be connected to a line, as
determined by the total RENs, contact the local
telephone company.
If trouble is experienced with your Superprint
Pro80
LVD, for repair or warranty information, please
contact Ultratec Inc. Customer Service at (608) 238-
5400 (V/TTY). If the equipment is causing harm to
the telephone network, the telephone company may
request that you disconnect the equipment until the
problem is resolved.
This equipment cannot be used on public coin phone
service provided by the telephone company.
Connection to party line service is subject to state
tariffs.
Your telephone company may discontinue your service
if your equipment causes harm to the telephone
network. They will notify you in advance of
disconnection, if possible. During notification, you
will be informed of your right to file a complaint to
the FCC.
Occasionally, your telephone company may make
changes in its facilities, equipment, operation, or
procedures that could affect the operation of your
equipment. If so, you will be given advance notice of
the change to give you an opportunity to maintain
uninterrupted service.
Other than replacing the batteries, the Superprint
Pro80
LVD does not have any user-serviceable parts.
7 0 • S P E C I F I C AT I O N S