Voltage
Output
Airflow
Temperatures
Protection class
120 V / 60 Hz
1750 W
up to 23 CFM, adjustable with baffle
Level 1: 80°F
Level 2: 750°F – 1000°F
II (without neutral lead connection)
Technical specifications
Double Insulated Tools
Tools marked with the words “Double Insulated” are equipped with a two prong plug.
These tools have a special insulation system that complies with applicable UL and CSA
standards. They do not require grounding. ”Double Insulated” tools, like this one, have
two prong cords and can use either a two or three prong extension cord.
“This appliance has a polarized plug (one blade is wider than the other). To reduce the
risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a quali-
fied electrician. Do not modify the plug in any way.”
Extension Cords
As the distance from the supply outlet increases,
heavier gauge extension cords are required. The use
of extension cords of inadequate size wire causes a
serious drop in voltage and loss of power. Protect the
cord from damage. Keep cords away from excessive
heat, sharp edges and damp or wet areas. Repair or
replace damaged extension cords before using.
English
Ext. Cord Length
Wire Size
85 Ft.
14
100 Ft.
12
170 Ft.
10
270 Ft.
0
8
400 Ft.
0
6
650 Ft.
0
4
For your safety
This heat tool incorporates a thermal fuse which automatically switches the device off in cases of
severe overheating.
English
Getting started
The device is switched on and
off with the selector switch on
the front of the handle. The dis-
tance from the object being
processed depends on the
material and the intended type
of processing. Always do an
initial test with regard to air vol-
ume and temperature. With the
optional accessory nozzles (see
accessories on page 3), the
hot air can be precisely target-
ed to specific points or sur-
faces.
Exercise caution when
changing hot nozzles!
When
you use the heat gun as a sta-
tionary device, ensure that it is
positioned securely on a clean
surface so that it cannot slip.
Operation
Level 1
is the cool air setting.
The temperature is approximate-
ly 80°F (room temperature). Use
the cool air function to dry paint,
to cool workpieces or to cool
the nozzle before changing an
accessory part. At
Level 2
the
blower temperature is 750 –
1000°F
Temperature Selection
Turn the baffle
to adjust
the air and temperature.
Turning the baffle toward LO
lowers the temperature while
increasing the airflow. Turning
the baffle toward HI increases
the temperature while decreas-
ing the airflow.
5
Adjustable Baffle
Support Stand
may be
adjusted or removed by loos
ening clamp screw. Stand
may be securely fastened to
work bench via holes in base.
6
Working with the stand
- 6 -
- 7 -
SV 750_UltraHeat_USA_3spr.qxd:SV 750_UltraHeat_USA_3spr.qxd 20.10.2009 10:26 Uhr Seite 8
