5
Attach the winder head to the sash bracket,
using the plunger pin. Hold the winder at
the relevant angle. Turn the winder body
clockwise until it locks with the sash bracket.
16
Apply downward force to the sash bracket
(see 1). Turn the connection collar until the
holes on the collar are approximately 3mm
above the holes in the winder bracket (see 2).
Holding the connection collar in place, turn
the winder body anti-clockwise to loosen the
sash bracket. This will enable you to
fi
t the
holding bolts without a
ff
ecting the winder
set-up.
15
FITMENT OF MECHANICAL WINDER
SECTION 4
20
Finished mounted motor in situ.
17
Using the nuts and bolts provided attach the
motor bracket to the sash bracket taking care
not to damage the glazed unit.
18a
19
Fit provided securing bolts into the motor
body through the location holes in the
brackets.
Note:
For further details, refer to motor instruction guide which can be located in the motor box.
FITMENT OF ELECTRIC MOTOR (IF SELECTED)
16
Align
1
2
Secure the brackets to the frame using
screws provided.
18b
18c
Mark out as shown 89mm from edge of
sash bracket to edge of motor bracket. Then
mark the holes using the motor bracket as
a template. Use a 2.5mm drill bit to pilot drill
through the frame.
Align motor brackets vertically using the
extrusions details as shown.
SECTION 4
89
89
Align here
14a
