Installation and Maintenance Manual
ULTRAFLEX
page 20
of 78 -
HYDRAULIC CYLINDER FOR OUTBOARD ENGINE
E
N
G
L
ISH
3.6.5 Dual steering station/dual cylinder
- Manually unscrew the two bleed valves
on the cylinder "T" fittings and push the
cylinders to one side up to the end stroke.
- Position the oil bottle near the main
steering station (upper) according to what
is described in paragraph 3.6.1.
Wait until the oil reaches the lower tank and
both tanks are filled.
- Follow the same purging procedure
described in paragraph 3.6.2 starting from
the lower station and repeat it for the upper
station.
WARNING
ATTENZIONE
- Repeat the entire procedure at least 4 times to ensure the absence of air in the system.
l
l
l
l
bleed valvers
black vent plug
silver
non-vent plug
WARNING
3.7 General recommendation
It is very important to check the absence of air in the system before using the boat! We recommend trying
to manually move the engine towards port and starboard, making sure that there is no movement of the
cylinder body on the main cylinder shaft.
If the cylinder body moves more than 1/6 inches (15mm), there is still air in the system. The air presence in
the system can cause bad responses to the controls and so it can cause damage, injuries or death.
WARNING
For the additional steering station (lower) tank use only the silver non-vent plug (supplied with the "kit OB-
2S"). For the main steering station (upper) tank use only the black vent plug.
- Repeat the procedure at least 3 times to ensure the absence of air in the system.
The purging procedure is the same for dual station, dual motor, single cylinder and tie bar.
WARNING
For the additional steering station (lower) tank use only the silver non-vent plug (supplied with the "kit OB-
2S"). For the main steering station (upper) tank use only the black vent plug.
NOTICE
Summary of Contents for UC 128-TS
Page 79: ......
Page 80: ...ULTRAFLEX S p A 16015 Casella Genova Italia Via Crose 2 ...
